Metal Corner Brackets
The two-by-four is – helps take the templates Metal Corner Brackets in place and temporarily hold them until the concrete’s being poured and so though it’s quite a process we ended up getting all that done important important process to do it takes a little bit of time but everything’s just got to be just right and once we’re done with that here are the anchor bolts now these are 3/4 inch by 12 inch anchor bolts and this is what we’re going to be using to put in the templates so we’re double knotting them you can see they’ve got a nut on the bottom nut on the top the bottom nut is the adjuster nut so once the concrete is poured we’re gonna be leaving the concrete down about two inches below the plywood and then we can adjust those nuts we’ll have to Congress before that we’ll take the template off and we’ll be able to adjust those nuts to make everything nice.
The level to help level out the columns as we put them on there well there it is we got all five templates and bolts complete and they’re ready for install fights off someone our regular viewers remember about a year ago I did phase one at this project right here and this is what that looks like massive fence building project we’re starting phase two now and here’s here’s where we’re at right here these are going to be set on some pad footings with some templates I’ve got the sill columns at the shop and working on the base plates for those but for right now this is what this looks like you know basically what we have here is footings that are four feet deep about three and a half to four feet wide the templates are set down they’re low the concrete is going to be going to the bottom of the plywood and then the plywood is going to be removed.
When the ply was removed then we’ll be able to stand Metal Corner Brackets the columns up on top of that bolt pattern so that’s what we got going on right here right now there’s five of these right here all along and it’s about 40 feet long total so that’s what we’re going to be doing be pouring some concrete here in just a little bit and getting it ready to install each pipe calls the truck goes into the pump and [Music] and there and then into the hole and it was kind of dark down there I don’t know if you guys can see it but Biscay we’re filling these holes up right here about two inches from the bottom of the plywood go support steel column when tomorrow upbeat song [Music] the easy process you know right involved no splatter the flat makes for a nice clean job anyways we got though we got five of these to do it’s the third one I’ll be over here in just a few minutes all right well there it is less than ten minutes.
