HOW TO FIX A DOORBELL

How many times have you missed a knock on the door just because your doorbell doesn’t work? In many cases, the doorbell really works, but in one Türklingel case, a few very simple pieces of the puzzle fail or prevent the entire process.

The doorbell system is really very simple.

You have a transformer that is usually in the basement or maybe in the garage. These look like a silver box with a couple of very small wires running off the top. The transformer does exactly what it sounds like. It converts a higher voltage into a lower voltage current that the bell needs to run.

The two wires

What comes from the transformer goes to the doorbell itself…or whatever part actually rings. Usually, the white wire is tied to one of the screws on the doorbell, while the other is tied to another wire that goes to the doorbell button. The single wire you see running from one point to the other has two wires inside the outer sheath. One wire carries the current to the button and the other carries it back. This means that on the doorbell you will need to tie both wires to each screw on the button.

So one screw has power, the other doesn’t.

When the button is pressed, current flows through the button and onto the other wire. This is then carried onto the bell itself and made to ring.

So if any of this caught your eye, you’ll understand that there are really only two parts that could go wrong with this equation. The assumption is that the wiring hasn’t changed… which means you haven’t done any other work recently. If you did, the wires may have been damaged at some point in the circuit.

If you haven’t done any work yet, check the button yourself.

Often the screws you connect the wires to become tarnished from exposure to the weather. In this case, no current flows through the button. To fix this, take the knob off and run some sandpaper over the connection points to remove the tarnish. Replace the knob and see if the bell works. If it doesn’t, then you most likely need to replace the transformer.

How to stop your dog from barking at the doorbell

people talk. birds are chirping. Dogs bark. It is within reason that dogs should bark. But when a dog’s bark is as steady as its breathing, that’s a big problem. A hyperactive dog will bark at everything and everyone, even if the doorbell rings.

It’s very embarrassing when a visitor rings your doorbell

This is a big problem unless you are a recluse and have no friends or are unfriendly with the neighbors . It’s very embarrassing when a visitor rings your doorbell and your dog presses against the door barking loudly and repeatedly.

Few people would stay and put up with the noise your dog makes. It would be very difficult to bring up a conversation with your canine disorder. Except for the dog jumping on your visitor and scaring him to death. This kind of scenario can be annoying and irritating. Stopping this type of behavior is not easy . But it is possible and requires a process known as desensitization.

The desensitization process involves several stages.

And for this to work, your dog should understand basic dog obedience training of the seat and foot. Once your dog is familiar with these commands, you can proceed with the steps below.

Step 1

Once your dog understands when to sit and heel, you can teach him to sit away from the door. If he does, reward him with a dog biscuit for his effort and staying in a sitting position.

Dogs are intelligent creatures. He knows that every time he fulfills your desires, he will get a reward. Don’t move on to Stage 2 until your dog is obeying you all the time.

Step 2

This includes teaching your dog to sit right in front of the door as you open it. If your dog refuses to sit when you open the door, correct it with a NO command and command him to sit again . Do this with him on a leash so you can lead him back to where he should be.

Step 3

This now affects a person at your door. Tell your dog to sit down. Only let your visitor enter when your dog is in a sitting position. If your dog stands Türklingel up, reprimand him with a NO. And again ordered to sit down. Note that your visitor will not enter the house until your dog has done it right.

Of course, practice with someone involved in your dog obedience training. A real visitor will wonder if you missed your doctor’s appointment.

Step 4

Finally, if you succeed with step 3, add the doorbell to the equation. This is the final piece of the puzzle and also the most challenging. If your dog hears the doorbell and responds, reprimand NO and tell him to sit or heel, if he does this correctly, reward him. Let him know when he’s doing it wrong and when he’s doing it right.