A Complete Guide To Solar Panel Mounting
Solar photovoltaic power plants’ output capacity is rising daily. Due to the fierce rivalry in the solar business, several bidders are lowering the standard of the solar module mounting structures. Understanding the various components and different kinds of mounting arrangements is crucial.
The solar PV modules are supported by mounting frames from an MMS Structure Manufacturer. It is crucial to pick the solar PV module mounting structure because it must sustain the solar PV module for 25 years since solar PV modules are intended to endure for 25 years.
Galvanized Iron:
Iron or steel is coated with zinc during galvanising to stop corrosion. There are several galvanising techniques. The hot dip galvanization process is the one most frequently used in module mounting structures. In hot dip galvanization, which takes place at a temperature of around 449 °C, the material being galvanised is immersed in molten zinc.
When iron or steel that has been galvanised is exposed to the environment, pure zinc combines with oxygen to generate zinc oxide, which then reacts with carbon dioxide to form zinc carbonate. Zinc carbonate is a sturdy substance that possesses a dull grey colour. It prevents corrosion on the substance underneath the coating. Iron is utilised for the galvanising process in the mounting framework for solar PV modules.
Mild Steel:
Iron ore and coal are combined to form mild steel in a furnace. Once the melting is complete, any impurities are burned out in another furnace. It contains just a very little amount of carbon, 0.5% to 0.25% of its weight. Mild steel is not frequently utilised by an MMS Structure Manufacturer in Mumbai when installing solar PV modules.
It is typically employed when lightweight constructions are required since the roofs are not very sturdy. Very little carbon makes up mild steel. It is incredibly malleable and can be machined into a variety of forms.
Aluminium:
The material aluminium is soft, flexible, and silvery white. It has a high level of corrosion resistance and does not corrode quickly. In comparison to galvanised iron, this is lighter and more affordable.
Mounting:
There are many roof kinds, thus it is necessary to build the solar PV module mounting structure with the roof type in mind.
● Flat Roof Mounted –
The mounting structures for solar PV modules are installed on a flat rooftop.
● Slope Roof-Mounted –
The slope-mounted solar PV module is used in messy areas. It might be an RCC concrete roof, a metallic roof, or an asbestos roof. To proceed with the solar PV installation, verify that the roof is at least 0.7m thick.
● Metal Sheet –
Metal sheets are widely used in manufacturing and industries.
● Asbestos Sheet –
Asbestos sheets are no longer in use. There are, nevertheless, a few sites where asbestos sheets are still utilised.
The mounting structure foundation must be sturdy enough to support the total load of the solar PV module mounting structure from the MMS Structure Manufacturer in India. The base must be drilled into the roof in the event of sloped roofs and ground installation. In the event of flat roofs, the foundation might be drilled into the roof or covered with concrete.
0
