HP Deskjet 3755 Setup(Guide)

Steps for HP Deskjet 3755 Wi-Fi Setup

Find a wireless network including a WPS-enabled access point and a computer combined to a wireless network.

First, you have confirmed that the computer And printer connected to the same connection Install printer software on your laptop/computer
Now click on WPS. Then you have to use the pin method then if your wireless router does not have a WPS button.
Tap and hold the Wireless button for more than 3 seconds on your printer for more than 3 seconds to enable WPS push mode. The wireless lamp starts blinking.
Tap the WPS button on the router. Wait while the connection is established which is shown when the product starts the timer about two minute
Now click on wireless and information at the same time.
This action will print a network configuration page. Get the WPS PIN at the top of the page.
Hold the button for 3 seconds and The cordless lamp begins to light up.
Open the wireless location detection software and type WPS PIN. Stop for two minutes. The wireless lamp will light up after the connection is made.

At the start, you have to push the power button to OPEN the printer.
Press and hold the Cancel and Wireless button simultaneously.
The power light starts flashing, which means the HP Deskjet 3755 is ready for wireless communication.
Now You have to install hp smart app on your laptop/computer
Then press and hold the wireless button for 3–4 seconds.
Now you see the light blink
The printer is now ready for wireless communication.
In this step, Go to your wifi router and look for the WPS button (front or back).
Press and hold the WPS button for 3–4 seconds on your route.
Now the blue or orange light of WPS will start flashing on your router.
Just wait for 2–3 minutes and the printer will automatically connect via wifi.