Solution To Fix Canon Printer Error 6c10
Canon printer error 6c10 is basically a CAM sensor error that occurs due to some fault in the printer’s ink absorber tank. Sometimes this error is quite difficult for the users to understand. The damaged ink cartridges is another prime cause for this error code to appear.
If the amount of ink collected at the base of the printer gets exceeded, then this will not allow you to use the printer and returns the error. With the help of a few effective workarounds, you can solve this matter. To know them, read the further sections.
Effective Techniques to Solve the Canon Printer Error 6c10
So the wait is over now. Try the following solutions one-by-one to fix the Canon mg5220 printer error 6c10 efficiently.
Technique 1: Reset the Canon Printer
Resetting the printer is the primary method to try. It allows the device to go back in time and help to fix several errors.
To reset your canon printer, perform the steps we have discussed below.
- Make sure the printer is not switched on.
- Press the Resume key and keep it held.
- Keep holding the Resume key, press, and hold the Power key.
- Now, wait until the green light is on. Then, slowly release the Resume key.
- Keep holding the Power key, press, and release the Reset key.
- Again press the Reset key. As you are already holding the Power key, so this time you need to release both the keys at the same time.
- Next, press the Resume key four times repeatedly and press the Power key again to reset the ink absorber counter.
Finally, when the reset is successful, restart the device and try printings to see if the Canon printer error 6c10 issue is now fixed or not. In case, the error is still present then try to clean the printer manually, which is another effective method to solve the error.
Technique 2: Clean the Ink Pad Manually
If the matter is too hard for the printer software to fix, then you need to proceed with the manual steps.
Hence, try these steps to clean the ink pad on your Canon printer.
- Turn on the printer and then remove the printer’s cover from the top.
- Now, put a pair of gloves on the hand to get the cartridge out of the device.
- Look for the flap directly inside the printer and remove the cartridges calmly one by one. Disconnect your printer from the power source.
- After that, force down on the head of each cartridge and shake them a bit to lose them up.
- Now, extract them out of the printer and clean the outline portion with a paper napkin (Do not damage the electrical contacts).
- Soak the cotton swab into the distilled water and clean the printhead with the wet cotton gently.
- Also, clean the foam pad. A foam pad is a component inside the printer which soaks the excess ink that gets out from the ink cartridges during the printing process. However, if the ink cartridges get leaked, then this will also drop the ink in the foam pad.
- After the cleaning process is successfully done, snap the components back to their actual location.
- Now, plug the device to the wall socket and turn on the printer to see if the error code is now fixed or not.
Hopefully, one of these methods might help you to overcome the Canon printer error 6c10 in no time.
In case, you are still failing to resolve the issue, then there might be some possibility of a printer hardware fault. You can service the Canon printer or get in touch with a hardware expert to deal with this error.
Content Source- http://toparticlesubmissionsites.com/solution-to-fix-canon-printer-error-6c10/
