How Do I Reset Schlage Keypad Lock Without Code?

ByAmeliakumar
Screenshot 2022-12-07 145954-48d15235

You’ve come to the right place if you’re seeking information on how to Reset Schlage Keypad Lock Without Code.

Everything you need to understand regarding Reset Schlage Keypad Lock Without Code is covered in this article. I’ll walk you through quickly resetting your Schlage keypad lock.

How Can a Schlage Keypad Lock Be Reset Without a Code?

You can reset a Schlage Keypad Lock without a code.

To Reset your Schlage Keypad Lock, Follow These Steps:

  • To remove the battery cover, slide it up. After that, unplug the battery.
  • Release the Schlage button after pressing it.
  • Replug the batteries in. After that, push and hold the Schlage button again until the lock beeps and the light goes green. Make sure you finish this process in 10 seconds.
  • Enter one of the default 4-digit codes (User Code) to check if the bolt swings and see if the reset did successfully. The reset was effective.
  • You don’t need to do anything else to reset your Schlage Keypad Lock. As you can see, no code needs to be entered

The Steps Listed Below To Reset Your Schlage Connect Deadbolt:

  • To remove the battery cover, slide it up. After that, unplug the batteries
  • Press and hold the Schlage button on the outside.
  • Attach the batteries whilst holding the Schlage button, then release it. This will reset the lock.
  • Press the outside Schlage button, then input one of the pre-programmed User Codes to verify that the reset was successful (4-digit code). After that, if the bolt moves, the reset is successful.

Change The Default Programming Code of 6 Digits

Typically, Schlage keypad locks have a 6-digit default Programming Code. Perhaps you’ve already updated the code; however, changing it now is necessary for security reasons because resetting the lock would return the default Programming Code.

The code is often printed on a white sticker that You may find on the rear of the keypad assembly in the user handbook (it requires removing the lock from the door).

Here is how to modify the 6-digit default Programming Code if you’re unsure how to do it:

  • When the Schlage button illuminates three orange lights and emits three beeps, enter the default programming code, which consists of six digits. Click the Schlage button after that.
  • When you press the Schlage button, three orange lights will appear on the keypad, a total of 3 beeps.
  • After entering a new programming code (6 digits), observe the Schlage button as it flashes orange three times and beeps three times.
  • To finish this process, enter the new programming code once more. After a lengthy beep, the Schlage button will turn green to show that the Programming Code has been successfully updated.

Where is the Schlage Lock’s Six-Digit Code Located?

The front of the lock’s user manual and the rear of the keypad assembly often contain the 6-digit programming code. You must first separate the lock from the door to access the code on the back of a keypad mechanism.

Conclusion

As previously stated, You can reset a Schlage Keypad Lock without a code. You may easily reset a lock by unplugging the batteries or hitting a few keys on the keypad so long as you have access to the interior or external assembly. You probably wouldn’t be able to reset the lock unless you’re locked out, which means you can’t get to the lock’s internal components. If so, try to unlock the door using a physical key and reset it once you have access to the interior assemble